Attachment installation

Overflow Adapter

Instructions:

For HL Drawers

  1. Pull out the drawer.

  2. Create space by removing 1-2 inserts.

  3. Reach your hand to the end of the gutter.

  4. Align the overflow adapter as shown in the picture.

  5. Attach the adapter to the gutter.

  6. Twist, rotate, and slide the adapter into the slot.

  7. Slide the adapter to the outer end of the gutter.

  8. Align the adapter with the inner wall of the gutter.

  9. Use the "hook + pull + push" method to secure the adapter.

For MG Drawers

  1. Pull out the drawer.

  2. Create space by removing the inserts.

  3. Reach your hand to the end of the gutter.

  4. Follow the same procedure as for the HL drawers: Align → Hook + Pull + Push.

 

Spacer


Instructions:

  1. Open the microgreen drawer.

  2. Remove the plants and inserts.

  3. Lift the plastic tray at the far left corner until you reach the corner of the metal drawer.

  4. Install the "Spacer" as shown in the video using the "Twist + Hook + Push In" method. (Video – 0:10)

  5. Slide the "Spacer" 22 cm from the left edge of the drawer towards the center, as shown in the video. (Video – 0:35)

  6. Once the "Spacer" is in position, rotate it as shown in the video and remove the adhesive tape. (Video – 0:23)

  7. Press the "Spacer" firmly so it adheres.

  8. Repeat the process on the right side of the drawer.

Note: The "Spacer" distance is 22 cm from the drawer edge to the center, as shown in the picture. The measurement does not need to be exact; an approximate positioning is sufficient.




Overflow Spacer


Instructions:

  • Open the microgreen drawer.

  • Remove the inserts to expose the overflow hole.

  • Unscrew the grey threaded part.

  • Apply the included Teflon tape.

  • Screw the grey threaded part back onto the brass connector until it stops.

  • If the part is too tight, remove a layer of Teflon tape and screw it again until it stops.

  • Place the template over the brass connector as shown in the video.

  • Ensure that the feet of the template lie flat on the plastic tray.

  • Unscrew the threaded part further until it reaches the template.